Smeg PV640S Manuale di Servizio Scaricare il pdf (Pagina 18)

Instructions for the installer

7.4 Distances to respect

IMPORTANT: In case of installation on an empty kitchen unit with doors, a

separation panel must be placed under the hob, which must be easily

extractable to allow sufficient access for any technical assistance.

Keep a minimum distance of 10 mm between the bottom of the appliance and

the panel surface (as shown in the figure).

If the appliance is instead on an oven installed under the hob, there is no need

to install a separating shelf. The oven must be equipped with a cooling fan.

7.5 Room ventilation

The room containing the appliance should have a permanent air supply in

accordance with the standards in force. The room where the appliance is

installed must have enough air flow needed for the regular combustion of gas

and the necessary air change in the room itself. The air vents, protected by

grills, must be the right size to comply with current regulations and positioned so

that no part of them is obstructed, not even partially.

The room must be kept adequately ventilated in order to eliminate the heat and

humidity produced by cooking: in particular, after prolonged use, you are

recommended to open a window or to increase the speed of any fans.

7.6 Extraction of the combustion products

The combustion products may be extracted by means of hoods connected to a

natural draught chimney whose efficiency is certain or via forced extraction. An

efficient extraction system requires precision planning by a specialist qualified in

this area and must comply with the positions and distances indicated by the

applicable standards. When the job is complete, the installer must issue a

certificate of conformity.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24 25 26

Nessun commento

Smeg PV640S Manuale di Servizio Pagina 18