Smeg PGA75FSC3 Manuale Utente

Summary 1 INSTRUCTIONS FOR SAFE AND PROPER USE________________ 4 2 POSITIONING OF THE HOB ________________________________ 6 3 GAS CONNECTION_____

Instructions for the installer 12 3 GAS CONNECTION This appliance is suitable for installation with Natural Gas or LPG (propane). Refer to page 12

Instructions for the installer 3.1 Electrical connection Make sure that the voltage and capacity of the power supply cable conform to the data sho

Instructions for the installer 14 4 ADJUSTMENT TO DIFFERENT TYPES OF GAS Before performing any cleaning or maintenance work, unplug the applianc

Instructions for the installer 4.2 Burner and nozzle characteristics table Burner ULPG – 2.75 kPa Nominal gas Consumption (MJ/h) Injector (

Instructions for the installer 16 5 FINAL OPERATIONS After carrying out the above adjustments, remount in reverse order to the instructions given i

Instructions for the user 6 USING THE HOB 6.1 Ignition of the burners Before turning on the burners, make sure that the flame-spreader crowns a

Instructions for the user 18 6.2 Practical advice for using the burners For better use of the burners and lower gas consumption, use covered cooking

Instructions for the user 7 CLEANING AND MAINTENANCE Before any intervention, disconnect the appliance from the mains. 7.1 Cleaning the stainle

Instructions for the user 20 7.3 Preventive maintenance This appliance does not need any special maintenance. However, a few simple operations have

Introduction 1 INSTRUCTIONS FOR SAFE AND PROPER USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIRETY AND

914773032/ C

Introduction THE APPLIANCE DATA PLATE, WITH TECHNICAL DATA, REGISTRATION NUMBER AND BRAND NAME, IS POSITIONED AT A VISIBLE POINT UNDER THE SAFETY CO

Instructions for the installer 6 2 POSITIONING OF THE HOB The following operation requires building and/or carpentry work so must be carried out by

Instructions for the installer 2.2 Attachment to support structure, flush-mounting model Create an opening with the dimensions shown in the figure

Instructions for the installer 8 Important: Other types of installation will only be possible under the manufacturer's supervision. Overall

Instructions for the installer 2.3 Clearance above and around domestic appliances Extract from AS5601 REQUIREMENTS 1 Overhead clearances – (Me

Instructions for the installer 10 2 Side clearances – (Measurements B & C) Where B, measured from the periphery of the nearest burner to any ver

Instructions for the installer Discharge of combustion products Discharge of combustion products must be guaranteed by means of hoods connected to